Inicio
Presentación
Recursos en linea
Curiosidades sobre el acero
Realizaciones
Proyectar con acero
Temas monográficos
Formación y ampliación de conocimientos
Publicaciones
 Inicio arrow Formación y ampliación de conocimientos arrow Worked Examples According to EN 1993-1-3
Advertisement

Worked Examples According to EN 1993-1-3

ECCS

ECCS has published document No. 114 Preliminary worked examples according to Eurocode 3 Part 1.3 (2000) prepared by ECCS TC 7 using the pre-standard ENV 1993-1-3.  This new publication replaces ECCS document No. 114. The examples have been updated following the provisions given in EN 1993-1-3. Some new examples have been also included. These examples show applicability of design provisions in EN 1993-1-3 in practice. They also help in the interpretation of the guidance given in the code.

Chapter 2 contains examples related to one industrial building. Different aspects related to the design of structural components have been included.
-Example A:  Roof sheeting
-Example B:  Liner trays
-Example C:  Purlins
-Example D:  Portal frames
-Example E:  End wall and wind bracing

Chapter 3 contains additional examples for specific structural elements or features of EN 1993-1-3, which are included to assist in practical use of the provision.
-Example F:  C-section in compression and bending about axis of symmetry
-Example G.  U-section in bending and compression
-Example H:  C-section in compression
-Example I:  Hat section upper chord of lattice girder
-Example J:  Sheeting with stiffeners in flange and web
-Example K:  Inelastic reserve of sheeting
-Example L:  Double C-section as end column

The calculations are based on the provisions of EN 1993-1-3. Also parts EN 1993-1-5 and EN 1993-1-1 are required in the calculations. In some cases engineering judgement has been followed. If other methods in addition to Eurocode 3 have been used it has been clearly noted in the examples.

This book has the price of 30 €

     http://www.eccspublications.eu

 

 

 

Buscador de aceros

Image

Buscador de aceros por designación numérica o simbólica,  norma  UNE o usos, obteniendo las denominaciones numérica y simbólica actuales (si se ha introducido una antigua), características mecánicas, composición química, norma UNE en la que aparece y usos del acero seleccionado.

 
39546_MQ.jpg

(C) 2019 APTA - Asociación para la Promoción Técnica del Acero